Services WAN Accelerator User guide

94 2 CONFIGURING THE HP EFS WAN ACCELERATOR
To set SNMP
parameters
1. Click the Setup tab to display the Setup menu.
2. Click Reports expand the Reports menu.
3. Click SNMP Settings to display the Reports - SNMP Settings page.
Figure 2-35. Reports - SNMP Settings Page
4. Use the controls to complete the configuration, as described in the following table.
5. Click Apply to apply your settings to the running configuration. (Apply your
settings to test a new configuration before committing it to memory.)
6. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
Setting SNMP
Trap Receivers
You set SNMP traps in the Reports - SNMP Trap Receivers page.
Traps are messages sent by an SNMP agent that indicate the occurrence of an event.
For detailed information about SNMP traps sent to configured servers, see“SNMP
Traps” on page 166.
Control Description
System Contact Type the user name for the SNMP contact.
System Location Type the physical location of the router.
Read Only Community Name Type a string to identify the read-only community. For example: public.