Manual

Power/UID module
The combined power/UID module allows you to power on/power off the enclosure, as well as identify
the device and all additional cascaded devices.
DescriptionItemDescriptionItem
System fault LED3UID button/LED1
Power/Standby button4System heartbeat LED2
• To illuminate the UID LEDs on this and all cascaded devices, press the UID button. UID LEDs on
the front and rear of the devices remain illuminated until the UID button is pressed a second time.
• To power on the enclosure, press and release the Power/Standby button.
• To place an enclosure in standby mode, press and hold the Power/Standby button for approximately
three seconds, or until the Power/Standby button LED changes from green to amber.
• To completely remove power from an enclosure, place the enclosure in standby mode, and then
disconnect all power cords.
NOTE:
• System power to the enclosure (and possibly other cascaded devices) does not completely shut
off with the Power/Standby button. When the enclosure is in standby mode, power is removed
from most of the electronics and components, but portions of the power supply and internal circuity
remain active.
• After a power failure, the system automatically returns to the last powered state (On or Standby)
when A/C power is restored.
Components12