Owner manual
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
1 Before you start
In this chapter:
• “HP StorageWorks DAT models” on page 13
• “Which operating systems are supported?” on page 14
• “Supplied cables” on page 14
• “Using the HP StorageWorks Tape CD-ROM” on page 16
HP StorageWorks DAT models
This guide describes how to install and operate the following HP StorageWorks DAT SAS tape drive
models:
• HP StorageWorks DAT 320
• HP StorageWorks DAT 160
For a detailed product specification, please refer to our World Wide Web site (http://www.hp.com).
4. Encryption LED1. Clean LED
5. Ready LED2. Tape LED
6. Eject button3. Drive LED
Figure 1 Front view of HP StorageWorks DAT 320 tape drive
.
DAT SAS Tape Drives 13