Owner manual
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
Secure the drive
1. Secure the drive, as described in your server documentation. The following diagrams are examples
only.
2. server latch, push down to lock the tape drive
into position
1. plastic rail
Figure 17 Securing drive example 1, mounting hardware used
.
1. M3 screws, supplied with tape drive
Figure 18 Securing drive example 2, no mounting hardware used
.
2. Ensure blanking plates are in place over empty bays and replace the cover on the server.
3. You are now ready to reboot the server.
Installing an internal DAT tape drive36