Owner manual
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
• Do not verify (DDS does read-after-write checking automatically).
• Do not overload the server during backups. Maximize the transfer rate (run overnight with no
other processes) and use incremental backups if convenient.
• Do not overuse your tape drive—it is designed for approximately three hours of tape pulling per
day, not constant usage—and clean the drive regularly. See “Cleaning cartridges” on page 53.
• If you want to bulk erase cartridges, this should be done in a controlled environment. You need
to make sure there are no other cartridges with sensitive information on them anywhere near the
bulk eraser when in use. All data will be lost on cartridges that are bulk erased.
DAT SAS Tape Drives 55