Owner manual
Table Of Contents
- DAT SAS Tape Drives
- Table of Contents
- About this guide
- 1 Before you start
- 2 Drivers and backup software
- 3 Installing an internal DAT tape drive
- 4 Installing an external SAS tape drive
- 5 Verify installation
- 6 Operating your tape drive
- 7 Use the correct media
- 8 Using HP OBDR
- 9 Diagnostic Tools and Performance
- 10 Troubleshooting
- 11 Replacing an internal tape drive
- A Connecting an external tape drive to an internal SAS port
- Index
6. Connect the replacement cable to the host SAS controller and attach the other end to the connector
for the highest-numbered disk bays.
3. Connect replacement SAS cable to disk bays1. Replacement split cable
2. Connect replacement SAS cable to host SAS HBA
Figure 36 SAS cable routing
.
Connecting an external tape drive to an internal SAS port78