Manual

2-7
Library Installation
Step 4: Connect the Library to the Host
Library Installation
5. For each bus, set the SCSI interface mode switch as follows.
Table 2-4 SCSI Interface Mode Switch Settings
CAUTION
Do not use a physical terminator.
If a physical terminator is attached and
termination is set to ON, the bus will be overterminated, which could cause
the device to function incorrectly.
Setting Purpose Set to
Term Pwr Sends termination
power to the bus
ON
Termination Terminates the SCSI
bus; functions the same
as a physical
terminator
ON if one port on the bus is
open
OFF if both ports on the bus
are connected to a cable