Manual

2-8

Library Installation

Step 5: Connect Power

Use the power cord shipped with the library.

1. Make sure the power switch on the front of the library is switched off.

2. Plug the power cord into the power port on the back of the library.

3. Plug the other end of the power cord into a three-hole grounded outlet.

4. Turn on the power switch.

SELF TEST and NOT READY alternately appear in the display window on

the library. Once the power on test completes (approximately 3 minutes),

the drive status information appears in the display window. (See

“Understanding the Display Window” on page 4-4.)

NOTE If the drive status information does not display, the power on test was not

successful and DEVICE FAILED displays. For troubleshooting procedures,

see “Troubleshooting” on page 4-41.

5. Turn on power to the host.