Manual

4-8
Library Operation
Setting a New Administration Menu Password
Setting a New Administration Menu
Password
1 2 3 4
➔
ADMIN*
➔
PSWD 000-000-000
➔
CONFIG*
➔
NEW PASSWORD
NOTE Do not forget the password. Only an HP qualified service representative can
reset the security code to the factory setting.
To set a new password:
1. Follow the steps on the previous page to enter the existing or factory-set
password.
2. Press
NEXT
until
CONFIG*
displays, then press
ENTER
.
3. Press
NEXT
or
PREV
until
NEW PASSWORD
displays, then press
ENTER
.
4.
NEW 000-000-000
displays, and the first set of zeros flashes.
Press
NEXT
or
PREV
until the desired number for the first part of the
password displays, then press
ENTER
.
5. The second set of zeros flashes.
Press
NEXT
or
PREV
until the desired number for the second part of the
password displays, then press
ENTER
.
6. The last set of zeros flashes.
Press
NEXT
or
PREV
until the desired number for the third part of the
password displays, then press
ENTER
.
7.
PASSWORD CHANGED
displays. Press
CANCEL
three times to return to the
drive status (“ready” state).
NOTE Save the new password to flash ROM by power cycling the library (turning
the library off and then on). This allows the password to be recovered if the
library is powered off for more than ten days.