Manual

4-29
Library Operation
Setting a Configuration Option
Library Operation
Setting a Configuration Option
1 2 3 4 ➔ ADMIN* ➔ PSWD 000-000-000 ➔ CONFIG*
Configuration options customize the way the library operates.
To change a configuration:
1. Verify that the drive status displays (if not, press
CANCEL
until it does).
2. Press
NEXT
until ADMIN* displays, then press
ENTER
.
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4. INFO* displays. Press
NEXT
until CONFIG* displays, then press
ENTER
.
5. Press
NEXT
or
PREV
to display the desired configuration option, then press
ENTER
. If the configuration has multiple settings, the current setting
flashes. Otherwise, the configuration option is set and OPTION SAVED
displays. (Configuration options are described in Table 4-8 on page 4-28.)
6. Press
CANCEL
to return to the drive status (“ready” state).
Table 4-8 Configuration Options
Config Name Description Default
RECOVERY
ON/OFF
ON Library attempts to recover from errors.
OFF Library immediately stops moving if an error
condition occurs.
Default is RECOVERY ON, and recovery should remain ON
under normal conditions.
ON
RESTORE
DEFAULTS
Sets all library configurations back to their default settings. —
CLEAR
ODOMETERS
Used by service personnel only.
Sets all library odometers back to zero.
—