User's Manual

scale: 1" = 1"
17 18 19 20
!
Reset
26478a
2
1
Figure 9 Locating the Reset button
Table 17 Locating t he reset but ton
Item
Description
1
Port side of switch
2
Reset button
Rebooting the switch
Depress the Reset button for up to 5 seconds to reboot the switch.
Replacing a faulty 8Gb SAN Switch
To replace a faulty switch in the c-Class enclosure:
IMPORTANT:
For supplemental information on any of these steps, refer to the latest
HP StorageWorks Fabric OS
administrator guide
and F abric OS Advanced Web Tools administrator guide ,availableattheHP
website:
nl
http:// www.hp.com/support/manuals
To access the guides, scr oll to the storage sectionofthewebpage,andselectStorage Networking for
HP StorageWorks products.
In addition to these guides, refer to the Brocade 8Gb SAN Switch for HP c‐Class BladeSystem—Setup,
Configuration and Installation Procedures available on h
ttp://ww w.hp.com for initial installation
instructions of the ne w switch.
1. Create a backup of the existing configuration fi le.
NOTE:
It is critical to back up the switch configuration to a remote server on a regular basis. Repeat
foreachswitchinyourSANwheneverconfiguration changes occur. Configuration b ackups
canbedonewiththeCLI,integratedWebToolsGUI,ortheoptionalFabricManagerGUI.
2. Locate the faulty switch.
3. Disconnect all external Fibre Channel cables.
4. Remove t
he faulty 8Gb SAN Switch from the enclosure.
5. Insert the replacement switch into the enclosure.
6. Log in to the Onboard Administrator C LI.
38
Managing the 8Gb SAN Switch