User's Manual

Power cords
The power cord se
t must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in
that country.
The power cord mu
st be rated for the product and for the voltage and current marked on the product
electr ical rat
ings label. The voltage and current rating of the cord shou ld be greater than the voltage and
current rating
marked on the product. In addition, the diameter of the wire must be a minimum of 1.00
mm
2
or 18 AWG, a
nd the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12 ft). If you have
questions ab
out the type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay particular at tention to the plug, electrical outlet, and the point where the cords
exit from the product.
Japanese power cord statement
Brocade 8Gb SAN Switch for HP BladeSystem c-Class
45