HP DesignJet Z2600 Z5600 PostScript Printer - User guide

8. Lower the blue lever.
9. Close the window.
10. Switch on the printer.
11. Reload the roll, or load a new sheet see Paper handling on page 32.
NOTE: If you nd that there is still some paper causing an obstruction within the printer, restart the procedure
and carefully remove all pieces of paper.
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-bleed print
or after the front-panel option Form feed and cut has been used, the cut strip remains in the output tray. Only
when the printer is not printing, reach into the tray and remove the strip.
128 Chapter 16 Troubleshooting paper issues ENWW