HP DesignJet Z2600 Z5600 PostScript Printer - User guide

Text messages (continued)
Message Recommendation
Remove [color] printhead Remove the incorrect printhead and insert a new printhead of the
correct type (color and number). See Handling ink cartridges and
printheads on page 99.
Replace [color] cartridge Replace the cartridge. See Handling ink cartridges and printheads
on page 99.
Replace [color] printhead Remove the non-functional printhead and insert a new printhead of
the correct type (color and number). See Handling ink cartridges
and printheads on page 99.
Reseat [color] cartridge Remove and reinsert the same cartridge. See Handling ink
cartridges and printheads on page 99.
Reseat [color] printhead Remove and reinsert the same printhead, or try cleaning the
electrical connections. If necessary, insert a new printhead. See The
front-panel display recommends reseating or replacing a printhead
on page 148.
Numerical error codes
Error code Recommendation
01.0, 01.1, 01.2 Restart the printer.
06:03 Restart the printer.
08:04 Restart the printer. If the problem persists, update the printer's rmware. See Update the rmware
on page 111.
08:08 Retry the operation that you were attempting. If it fails again, restart the printer. If the problem
persists, update the printer's rmware. See Update the rmware on page 111.
21, 21.1, 21:03, 21.1:03, 21:13,
21.2:13, 22.0, 22.1, 22.2, 22.3,
22.x:03, 24
Restart the printer.
26:01, 26.x:01 Bad contact detected in an ink cartridge (if present, x refers to the cartridge in slot x). Remove and
reinsert the cartridge. If necessary, insert a new cartridge.
26:14 Update your printer's rmware. See Update the rmware on page 111.
27:01, 27.x:01 Too many printhead nozzles are not working (if present, x refers to the printhead in slot x). Remove and
reinsert the printhead, or try cleaning the electrical connections. If necessary, insert a new printhead.
See The front-panel display recommends reseating or replacing a printhead on page 148.
27:03 Printhead error. Restart the printer.
27:14 Update your printer's rmware. See Update the rmware on page 111.
31:03, 41:03, 42:03, 45.1:03,
45.2:03, 47:03, 56:03
Restart the printer.
61:01 The le format is wrong and the printer cannot process the job. If the job is password-protected, try
sending it without password protection. Otherwise, update your printer's rmware and try again. See
Update the rmware on page 111.
61:04.1, 61:04.2 Update your printer's rmware. See Update the rmware on page 111.
61:08.1 Resend the job without password protection.
66:08 The job cannot be printed on the paper type that is loaded.
68:03 Restart the printer.
71.04 Out of memory.
160 Chapter 20 Front-panel error messages ENWW