HP DesignJet Z2600 Z5600 PostScript Printer - User guide

Numerical error codes (continued)
Error code Recommendation
71:03 Restart the printer.
74:04, 74.1:04 The rmware update has failed. Press OK and try again. See Update the rmware on page 111.
74.1 Try the rmware update again. Do not try to use your computer while the update is in progress.
74.8:04 The rmware update has failed. Your rmware le may be incorrect; try to download it again. See
Update the rmware on page 111.
76:03 Restart the printer.
77:04, 78.1:04 Update your printer's rmware. See Update the rmware on page 111.
78:08 Borderless printing not possible; setting ignored..
79:03 Restart the printer.
79:04, 79.1:04 Update your printer's rmware. See Update the rmware on page 111.
81:01 Follow the instructions on the front panel. You may be asked to run a test procedure and write down a
numeric code before contacting HP Support. See Contact HP Support on page 164.
81:03, 84:03 Restart the printer.
86:01 Follow the instructions on the front panel. You may be asked to run a test procedure and write down a
numeric code before contacting HP Support. See Contact HP Support on page 164.
94, 94.1, 94:08 Restart color calibration. See Color calibration on page 74.
94:02 Color calibration failed. Check that the paper type that is loaded corresponds to the paper type that you
have selected.
The system error log
The printer saves a log of system errors that you can access in the following ways.
Using a USB ash drive
1. Create an empty le named pdipu_enable.log in a USB ash drive.
2. Insert the USB ash drive into the Hi-Speed USB host port at the front of the printer. The log will be
automatically copied into the drive.
Using the Embedded Web Server
1. In your Web browser, go to http://printer IP address/hp/device/webAccess/log.html.
2. The Embedded Web Server will send you a le called log.tar.gz containing the system error log.
ENWW The system error log 161