HP EliteOne 800 G2 23 inch All-in-One HP EliteOne 705 G2 23-inch Touch All-in-One HP ProOne 600 G2 21 inch All-in-One - Maintenance & Service Guide

Memory
Description
8-GB
4-GB
2-GB
The computer comes with small outline dual inline memory modules (SODIMMs).
The memory sockets on the system board can be populated with up to two industry-standard SODIMMs.
These memory sockets are populated with at least one preinstalled SODIMM.
For proper system operation, the SODIMMs must meet the following qualications:
EliteOne 800 and ProOne 600 EliteOne 705
SODIMM 1.2 volt DDR4-SDRAM SODIs 1.5 volt DDR3-SDRAM SODIs
Compliance unbuered non-ECC PC4-10600 DDR4-2133 MHz-
compliant
unbuered non-ECC PC3-10600 DDR3-1600 MHz-
compliant
Pins industry-standard 260 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specication
industry-standard 204 pin containing the
mandatory Joint Electronic Device Engineering
Council (JEDEC) specication
Support support CAS latency 11 DDR4 2133 MHz (11-11-11
timing)
support CAS latency 11 DDR3 1600 MHz (11-11-11
timing)
Slots 2 2
Maximum Memory 32 GB 16 GB
Supported 1 Gbit, 2 Gbit, and 4 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
Note The system will not operate properly if you install unsupported SODIMM memory. SODIMMs constructed
with x8 and x16 SDRAMs are supported; SODIMMs constructed with x4 SDRAMS are not supported.
HP oers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
The system will automatically operate in single channel mode, dual channel mode, or ex mode, depending
on how the SODIMMs are installed. Refer to the following table to identify the SODIMM channel locations.
Location System board label Channel
Lower Socket SODIMM1 Channel B
Upper Socket SODIMM3 Channel A
Memory 49