User Guide - Windows 7

1. Select Start > All Programs > Intel > Intel Rapid Storage Technology.
2. Click the Acceleration link, and then click the Disable Acceleration link.
3. Wait for the Acceleration Mode to complete.
4. Click the Reset to Available link.
IMPORTANT: You must temporarily disable SRT when changing RAID modes. Make the change and then re-
enable SRT. Failure to temporarily disable this feature will prevent you from creating or changing RAID
volumes.
NOTE: HP does not support SRT with self-encrypting drives (SEDs).
Removing or replacing the service door
Removing the service door
Remove the service door to access the memory module slot, hard drive, and other components.
1. Remove the battery (see Removing a battery on page 38).
2. With the battery bay away from you, remove the screw plug (1) and then loosen the service door screw
(2).
3. Slide the service door toward the front of the computer (3) and lift (4) to remove the service door.
Replacing the service door
Replace the service door after accessing the memory module slot, hard drive, regulatory label, and other
components.
Using hard drives 47