HP ENVY Notebook Intel Models 17-n100 17-n199 3D camera Models 17-r100 17-r199 (worldwide) 3D camera Models m7-r100 m7-r199 (North America) - Maintenance and Service Guide

Display assembly – touch screen
Component Spare part number
Display enclosure 813789-001
Display enclosure 3D camera 832351–001
Brackets (left and right, includes screw) 818092-001
Hinges (left and right, includes screw covers) 813802-001
Hinges 3D camera (left and right, includes screw covers) 832356-001
Antennas (includes wireless antenna cables and transceivers) 813787-001
Touch control board 818094-001
Webcam module 812715-001
Webcam module 3D camera 832360-001
Webcam module antennas 813787-001
Display cable 813792-001
Display cable FHD 3D camera 832353-001
Display cable 3D camera 832354-001
Display Panel 813803-001
Display Panel FHD at 3D camera 832357-001
Bezel 3D camera 832352-001
To remove the display assembly and access the display assembly subcomponents, follow these steps:
NOTE: To remove the touch screen, the hinges are under the system board and it must be removed. For the
non-touch screen display, you do not need to remove the system board.
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see Battery on page 27).
5. Remove the optical drive (see Optical drive on page 28).
6. Remove the bottom cover (see Bottom cover on page 31).
7. Remove the hard drive (see Hard drive on page 34).
8. Remove the speakers (see Speakers (front) on page 47).
9. Remove the system board (see System board on page 49).
Remove the display assembly:
1. Open the computer and position the computer with the display hanging over the edge of a tablet.
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts