Operation Manual
Table Of Contents
- Get started
- Printer parts
- Set up tray and load media
- Connect your printer
- Manage cartridges
- Copy and scan using HP Smart
- Solve a problem
- HP EcoSolutions (HP and the Environment)
- Technical information
- Specifications
- Regulatory notices
- Regulatory model identification number
- FCC statement
- VCCI (Class B) compliance statement for users in Japan
- Notice to users in Japan about the power cord
- Power cord instructions
- Noise emission statement for Germany
- European Union Regulatory Notice
- Visual display workplaces statement for Germany
- Regulatory wireless statements
- Environmental product stewardship program
- Eco-Tips
- Paper
- Plastics
- European Union Commission Regulation 1275/2008
- Safety data sheets
- Chemical substances
- EPEAT
- SEPA Ecolabel User Information (China)
- Recycling program
- HP inkjet supplies recycling program
- Power consumption
- China Energy Label for Printer, Fax and Copier
- Disposal of waste equipment by users
- Waste disposal for Brazil
- The Table of Hazardous Substances/Elements and their Content (China)
- Restriction of hazardous substance (India)
- Restriction on hazardous substances statement (Turkey)
- Declaration of the Presence Condition of the Restricted Substances Marking (Taiwan)
- Index
Connect to a wireless network with a router
TIP: To print the Wireless Quick Start Guide, press and hold until all the buttons on the control panel
light up, and then press again.
●
Connect your printer to a wireless network using Wi-Fi Protected Setup (WPS)
●
Connect your printer to a wireless network using HP printer software
Connect your printer to a wireless network using Wi-Fi Protected Setup (WPS)
Before you can connect your printer to a wireless network using WPS, make sure you have the following:
● A wireless 802.11b/g/n network that includes a WPS-enabled wireless router or access point.
NOTE: The printer only supports connections using 2.4 GHz and 5 GHz.
● A computer connected to the wireless network that you intend to connect the printer to. Be sure you
have installed the HP printer software on the computer.
If you have a WPS router with a WPS push button, follow the Push Button method. If you are not certain your
router has a push button, follow the PIN method.
To use the Push Button Conguration (PBC) method
1. Press and hold and on the back of printer for at least three seconds to start WPS Push Button
method.
The Edge lighting shows two small bars glowing blue and the outside edges of the large light bar pulsing
blue, repeating.
2. Press the WPS button on your router.
NOTE: The product begins a timer for approximately two minutes while a wireless connection is established.
If the printer connects successfully, the large light bar of the Edge lighting glows light blue in the center.
30 Chapter 4 Connect your printer ENWW