- Hewlett-Packard Network Card User Manual

Appendix I Installing the Visual Diagnostic Panel
NOTE The Visual Diagnostic Panel depends on information collected
by the HP Server Remote Management Card and will work
only if the Remote Management Card is installed. This is the
reason for shipping the Visual Diagnostic Panel together with
the HP Server Remote Management Card.
Installing the Diagnostic Panel in the tc3100 HP
Server
Installing the Diagnostic Panel
1. Power down the HP Server.
2. Disconnect the power cord(s).
WARNING The power supplies continue to provide standby voltage to the
HP Server until the power cord(s) is/are disconnected.
3. Remove the cover.
4. Snap the Diagnostic Panel into place, as shown in Figure I-2.
NOTE Wear a wrist strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
that the metal of the wrist strap contacts your skin.
Connecting the Cable
The Visual Diagnostic Panel for the tc3100 HP Server is shipped with a cable that
has a small connector at one end and a large connector at the other end. Plug the
small cable connector into the Diagnostic Panel after it has been snapped into
place and then plug the large cable connector into the Server’s motherboard, as
shown in the figure.
108