- Hewlett-Packard Network Card User Manual

Chapter 6 Setting Up NT Graphics Console Redirection Using pcAnywhere

Installing pcAnywhere on the Server

To enable console redirection (the ability to redirect what's graphically displayed

on your server) either over the LAN or via modem, you must first install the

pcAnywhere host software, included with your system, on your HP Server.

NOTE Remember that the HP Server Remote Management Card

software license authorizes a single administrator for each

copy of software (including Symantec's pcAnywhere).

Console Redirection Over a LAN

If you want console redirection (remote control) of your server over a LAN

(instead of using a modem with pcAnywhere), you must have TCP/IP software

installed on your server. TCP/IP is available with the standard Windows NT

product.

Installing pcAnywhere Server Software

Installing pcAnywhere at the server requires administrator privileges in order to

configure the program's communications features. Your server must be running

either Windows NT 4.0 or Windows 2000.

To install the pcAnywhere software on your Windows server:

1. Log in to Windows with administrator privileges. You need to be the

system administrator, or have an account that belongs to the administrator

group.

2. Insert the HP Netserver Navigator CD (supplied with the HP Server

Remote Management Card) in the CD-ROM drive.

3. If you want to run pcAnywhere via the modem connected to the HP Server

Remote Management Card, install the appropriate serial driver by running

one of the following driver setup programs.

For Windows NT 4.0, the driver is located in:

x:\ttrc2\us\nt40drvr\setup.exe

For Windows 2000, the driver is located in:

x:\ttrc2\us\win2kdrvr\install.exe

where x: is the letter of your CD-ROM drive. Follow the on-screen setup

instructions.