- Hewlett-Packard Network Card User Manual

1 Quick Start

This chapter provides a quick overview of the steps required for setting up and

using the HP Server Remote Management Card. If you have experience setting up

computer hardware and software, you can use the following section as a brief

installation guide. Before installing the HP Server Remote Management Card, you

must already have completed initial installation and configuration of your HP

Server. For a brief overview of how the HP Server Remote Management Card

works, see Figure 2-1 before proceeding.

Before you begin, review the "HP Server Remote Management Card System

Requirements" section of Chapter 2.

Figure 1-1. The HP Server Remote Management Card PCI Card Connectors

Install and connect the Remote Management Card (see Chapter 3 for detailed

instructions):

1. Connect one end of the supplied 50-pin ribbon cable to the connector on

the HP Server Remote Management Card.