Manual

HP T750 G2, HP T750J, HP T1000 G3, HP T1000J, HP T1500 G3, and HP T1500J UPS Models User Guide S 505922-002
13
Chapter 5 Additional UPS Features
This section describes:
S Voltage configuration
S USB port and serial port
S Network transient protector
S HP Power Manager software
Voltage Configuration
The DIP switches on the rear panel of each unit (see Figure 14) are used to configure
the output voltage and input voltage range.
To configure voltage:
1 The UPS must be completely shutdown.
To turn off the UPS, press and hold the
(On/Off) button for two seconds and
then unplug the UPS from the power outlet.
2 Set the DIP switches according to the configurations in Table 1 on page 14.
3 Plug the UPS power cord into a power outlet.
4 Press and hold the
(On/Off) button until you hear the UPS beep to turn the UPS
on.
UPS Rear Panel
ON
OFF
21
Figure 14 DIP Switches