User's Guide

Canada modem statements
This equipment meets the applicable Industry Canada technical specications.
The Ringer Equivalence Number, REN, is an indication of the maximum number of devices allowed to be
connected to a telephone interface. The termination on an interface may consist of any combination of
devices, subject only to the requirement that the sum of the RENs of all devices does not exceed 5. The REN
for this terminal equipment is 1.0.
Japan modem statements
If the computer does not have the Japanese certication mark on the bottom of the computer, refer to the
appropriate certication marking below.
The Japanese certication mark for the V.92 56K Data/Fax Modem is below:
If the computer does not have the Japanese certication mark on the bottom of the computer, refer to the
appropriate certication marking below.
The Japanese certication mark for the LSI Corporation PCI-SV92EX Soft modem is below:
New Zealand modem statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any
item will work correctly in all respects with another item of Telepermitted equipment of a dierent make or
model, nor does it imply that any product is compatible with all of Telecom's network services.
This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for
which it is designed. Telecom will accept no responsibility should diiculties arise in such circumstances.
If this device is equipped with pulse dialing, note that there is no guarantee that Telecom lines will always
continue to support pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to
bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user should
not contact the Telecom Faults Service.
Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the
equipment (PC) associated with this device. The associated equipment shall be set to operate within the
following limits for compliance with Telecom's Specications:
12 Chapter 1 Regulatory notices