Installation guide

Meridian MAX system configuration 9-43
Meridian MAX Installation Guide Product release 8
This message is followed by another message that explains what fields need
to be adjusted to avoid data loss. For example, the following message
explains the potential trunk data loss:
If you do not wish to lose data, please adjust storage duration
fields, avg. calls per hour or trunk level report. If trunk
level report is OFF, you may also adjust the number of routes.
If it is ON, you may adjust the number of trunks, the trunk
reassignment percentage, the number of call transfers received
per queue or the number of primary answering queues.
For more information, refer to the Meridian MAX Maintenance and
Diagnostics Guide.
Press ENTER to continue.
Press {RETURN} to return to the Advanced Capacity Configuration
screen. Change the fields listed in the message and repeat the validation
until no data loss occurs.
Column headings
Expected
This column shows the expected or required capacity for the configuration
shown. The initial values in this column are calculated from the parameters
entered in the Basic Capacity Configuration screen, for a new installation,
or from the previous expected capacity values for a Meridian MAX
upgrade or capacity reconfiguration.
Measured/Default
If you select the “Current” configuration view (if enabled), this column
shows the measured values of the current Capacity Configuration
parameters.
Note: Detailed field descriptions for the Advanced Capacity Configuration
screen’s measured values are shown in Table 9-6.
If you are configuring a new system, the “Default” column shows the
default values for the expected limits. The values are preset or derived from
the values entered on the Basic Capacity Configuration screen.
The system limits, though not seen in the previous screen, do exist for some
of the “Expected” values. Press [Options] to see the valid ranges.