Installation guide

Meridian MAX installation checklist 15-3
Meridian MAX Installation Guide Product release 8
Software installation
Providing you have completed the hardware installation, proceed with the
software installation. If you performed a new SNN/SNN-E or IPE/IPE-E
software installation, refer to the “New software installations” chapter. If
you installed a more recent issue of your existing software, refer to the
“Loading a new software release” chapter. If you performed a software
reinstallation or upgrade, refer to the “Software reinstallations and
upgrades” chapter.
Capacity Configuration worksheets _______________________
completed ?
Ensure that the Capacity Configuration worksheets are completed and
approved. For more information, refer to the “Meridian MAX system
configuration” chapter.
Software installed (if necessary) ? _______________________
Ensure that the workstations are configured for the system. For more
information, refer to the “Workstation, HSL, and LML configuration”
chapter.
Workstation Configuration completed ? _______________________
Software Installation completed ? _______________________
Operating modes
Make sure that all supervisors and system administrators have had the
opportunity to learn to use the system while in the training mode. For more
information, refer to the “Operating modes” chapter, “Training mode”
section.
Training completed ? _______________________
Switch from training mode to precutover mode. For more information, refer
to the “Operating modes” chapter, “Precutover mode” section .
Precutover Mode started ? _______________________