HP FlexFabric Virtual Switch 5900v Configuration Examples

# On the HP Port Group 5900v tab, click the link in the VLAN column to configure VLAN settings

for the port group.

Figure 43 Clicking the VLAN link for the port group

# Select VLAN Access, enter the VLAN ID for mail service, and then click OK.

NOTE:

For downlink ports (virtual NICs), you must set the link type to Access.

Figure 44 Configuring VLAN settings

# On the HP Port Group 5900v tab, click the link in the VDP column to associate the downlink port

group with the network and VSI type settings.

NOTE:

EVB uses the VSI Discovery and Configuration Protocol (VDP) to maintain VSIs and associations of

SIs and brid

e ports on the physical access switch for VMs. For more information about EVB and

DP, see the EVB confi

uration

uide for the physical switch.

Figure 45 Clicking the VDP link for the port group

# Select the network, VSI type, and VSI type version configured on HP IMC for mail service, and

then click OK.

NOTE:

ith HP IMC, you can revise the settings of a VSI type. Each time a revised VSI type is released, HP

IMC creates a new version of the VSI type. If a VSI type has been revised multiple times, The VSI Type

ersion list will contain multiple versions. You must make sure the correct version is selected.