HP FlexFabric Virtual Switch 5900v Configuration Examples

After the port group configurations for the VMs are completed, the HP 5900v obtains network

policies for the VMs after the VMs are powered on. IMC then issues the policies to the HP 5900

switch.

2. Verify that IMC has issued the network policies to the HP 5900 switch.

# Display brief VSI information for Bridge-Aggregation 1.

<Sysname> display evb vsi interface Bridge-Aggregation 1

Status: A -- Association, P -- Pre-association

VSI VTID Type Instance Status

interface version ID

SCH-AGG1:1.0 1 1 103bd0b7f6e9b8d520d... A

SCH-AGG1:1.1 3 1 e13ae2070aff522ec33... A

The output shows that two VSIs have been created.

# Display brief VSI information for Bridge-Aggregation 2. (Details not shown.)

# Display the running configuration on Bridge-Aggregation 1.

<Sysname> system-view

[Sysname] interface Bridge-Aggregation 1

[Sysname-Bridge-Aggregation1] display this

interface Bridge-Aggregation1

evb enable

port link-type trunk

undo port trunk permit vlan 1

port trunk permit vlan 100 200

The output shows that Bridge-Aggregation 1 has been assigned to VLAN 100 and VLAN 200.

# Display the running configuration on Bridge-Aggregation 2. (Details not shown.)

# Display information about the QoS policy applied to the incoming traffic of

Schannel-Aggregation 1:1.

<Sysname> display qos policy interface Schannel-Aggregation 1:1

Interface: Schannel-Aggregation1:1.0

Direction: Inbound

Policy: Schannel-Aggregation1:1.0

Classifier: inClass-0050-568d-7f98-3034

Operator: AND

Rule(s) :

If-match acl 3034

Behavior: InBehav-0050-568d-7f98-3034

Filter enable: Permit

Marking:

Remark dot1p 3

Committed Access Rate:

CIR 100000 (kbps), CBS 6250496 (Bytes), EBS 512 (Bytes), PIR 200000 (kbps)

Green action : pass