HP FlexFabric Virtual Switch 5900v Configuration Examples

[Sysname-vlan100] quit

[Sysname] vlan 200

[Sysname-vlan200] quit

[Sysname] vlan 300

[Sysname-vlan300] quit

# Create aggregate interface Bridge-Aggregation 1. Assign the ports connected to ESXi host 1

(Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2) to aggregation group 1.

[Sysname] interface Bridge-Aggregation 1

[Sysname-Bridge-Aggregation1] quit

[Sysname] interface Ten-GigabitEthernet1/0/1

[Sysname-Ten-GigabitEthernet1/0/1] port link-aggregation group 1

[Sysname-Ten-GigabitEthernet1/0/1] quit

[Sysname] interface Ten-GigabitEthernet1/0/2

[Sysname-Ten-GigabitEthernet1/0/2] port link-aggregation group 1

[Sysname-Ten-GigabitEthernet1/0/2] quit

# Enable LLDP globally. You must enable LLDP because EVB uses LLDPDUs to transmit channel control

messages.

[Sysname] lldp global enable

# Set the IP address and port number of the default VSI manager (HP IMC) to 192.168.20.35 and 8080,

respectively. This information is required for the 5900 switch to obtain network policies for VMs from the

VSI manager.

[Sysname] evb default-manager ip 192.168.20.35 port 8080

# To allow traffic from both VLAN 100 and VLAN 200 to pass through, configure Bridge-Aggregation 1

as a trunk port.

[Sysname] interface bridge-aggregation 1

[Sysname-Bridge-Aggregation1] port link-type trunk

Configuring Ten-GigabitEthernet1/0/1 done.

Configuring Ten-GigabitEthernet1/0/2 done.

# Enable EVB on Bridge-Aggregation 1.

[Sysname-Bridge-Aggregation1] evb enable

# To enable Bridge-Aggregation 1 to quickly connect to the server, configure it as an STP edge port.

[Sysname-Bridge-Aggregation1] stp edged-port

# Create aggregate interface Bridge-Aggregation 2. Assign the ports connected to ESXi host 2

(Ten-GigabitEthernet 1/0/3 and Ten-GigabitEthernet 1/0/4) to aggregation group 2.

[Sysname] interface Bridge-Aggregation 2

[Sysname-Bridge-Aggregation2] quit

[Sysname] interface Ten-GigabitEthernet1/0/3

[Sysname-Ten-GigabitEthernet1/0/3] port link-aggregation group 2

[Sysname-Ten-GigabitEthernet1/0/3] quit

[Sysname] interface Ten-GigabitEthernet1/0/4

[Sysname-Ten-GigabitEthernet1/0/4] port link-aggregation group 2

[Sysname-Ten-GigabitEthernet1/0/4] quit

# Configure Bridge-Aggregation 2 as a trunk port.

[Sysname] interface bridge-aggregation 2

[Sysname-Bridge-Aggregation2] port link-type trunk

Configuring Ten-GigabitEthernet1/0/3 done.