HP FlexFabric Virtual Switch 5900v Installation Guide

Figure 8 Selecting the format to store the VCE virtual disks

NOTE:

For information about how to select the disk format to store VCE virtual disks, see online help.

10. On the Properties page, configure properties for the virtual switch.

The VCE must work with HP IMC and VMware vCenter Server. The property information is used for

establishing connections with HP IMC and VMware vCenter Server.

IMPORTANT:

Make sure the information you provide is correct. All property information on this pa

e is required

and cannot be changed after VCE installation.

a. In the VCE IP Address area, enter the following configuration information for the VCE:

− IP address.

− Subnet mask.

− Default gateway.

− DNS name (HP-VCE by default).