HP FlexFabric Virtual Switch 5900v Troubleshooting Guide

11
3. If no connection exists between the VCE and vCenter Server, click Connect. The icon is
displayed.
4. Refresh the configuration page.
5. If the problem persists, contact HP Support.
Error message displayed when operations are
performed on the 5900v after VCE deployment
Symptom
The system displays an error message "License error: VCE VM's location changed" when operations are
performed on the 5900v after VCE deployment, even if the VCE is restarted.
Solution
To resolve the problem:
1. Specify an IP address not used by other VMs on the vCenter Server for the VCE when deploying
the VCE.
2. If the problem persists, contact HP Support.
VFE batch installation page does not respond
Symptom
1. Select multiple ESXi hosts where the number of CPUs has exceeded the license limit to install VFEs.
2. Click Install, and then switch to another page.
The system displays an error message: "License error, exceed authorization number of CPU.".
3. Return to the VFE installation page. The page does not respond.
Solution
This symptom occurs because you switch to another window when VFEs are being installed or removed
in batches.
To resolve the problem:
1. Minimize the window and close the error prompt window.
2. If the problem persists, contact HP Support.