Programming instructions

76 Chapter 3
Troubleshooting
Selftest Failures
FLT CBFF SYS BD multiple HPMCs
A High-Priority Machine Check occurred
while processing another HPMC.
INI CC0
n
SYS BD CPU
n OS rendezvs
Slave CPU n entering the final
rendezvous, waiting for the operating
system to awaken it.
INI CC1
n
SYS BD CPU
n early rend
Slave CPU n entering the early
rendezvous, waiting for the monarch CPU
to initialize scratch RAM and other
system state.
INI CC2
n
SYS BD CPU
n rendezvous
Slave CPU n entering rendezvous. Slave
CPUs enter this rendezvous numerous
times during boot.
INI CC3
n
SYS BD CPU
n cache rend
Slave CPU n entering cached rendezvous,
waiting for the monarch CPU to configure
the system bus.
INI CC4
n
SYS BD CPU
n mem rendez
Slave CPU n entering memory
rendezvous, waiting for the monarch CPU
to select a boot device.
TST D000 SYS BD micro controller
Firmware is initializing communications
with the system controller.
WRN D004 SYS BD micro not resp
Firmware detected a communications
error with the system controller.
INI D005 SYS BD set dom1 fan spd
Firmware is initializing communications
with the system controller.
INI D006 SYS BD set dom2 fan spd
Firmware is initializing communications
with the system controller.
WRN D007 SYS BD bad microctl cmd
Firmware detected a communications
error with the system controller.
FLT D01
n
SYS/IO fan
n : failure!
Firmware detected fan n stopped.
WRN D02
n
SYS/IO fan n : too slow!
Firmware detected fan n is running too
slowly.
Table 3-2. Chassis Codes for the B2000 Workstation
Ostat Code FRU Message
Description