Owner manual

206 HP VMA SAN Gateway User’s Guide AM456-9026A
Use the container <container_id> option to restrict statistics display to a single container. If
it is omitted, statistics are shown for all the containers accessible to the hosts.
Use the
name <lun_name> option to get statistics for a single LUN. If it is committed, statistics
for all LUNs are specified.
Note: Select shell wildcard patterns can be used in the <lun_name> field to match a set of LUNs.
For example, you can use the asterisk (*) to match all characters that follow. Such as
mylun* to
match all LUN names that begin with "mylun". Or, you can specify a range of LUN names using
the [a-e] wildcard. Such as my-lun[2-4][0-9] to match all LUNs from my-lun20 to my-lun49.
Use the
on global option to get statistics for data flowing to LUNs through all nodes in a cluster.
Use the
on host <hostname> option to get statistics for data flowing to LUNs on a specific host.
Use the
continuous option to refresh displayed statistics every ten seconds.
Use the
detail option to display statistics in a verbose format.
Quick Reference to Commands
This section lists the commands that are documented in this guide; it does not include every
command that is available in the CLI.
S: Standard Mode
E: Enable Mode
C: Configure mode
no Variant Command
See section starting on
page #
C[no]
aaa
page 192
C[no]
arp
page 191
C[no]
banner
page 198
E, C [no]
boot
page 176
S, E, C [no]
cli
page 198
C[no]
clock
page 160
C[no]
cluster heartbeat enable
page 181
C[no]
cluster master address vip
page 181
C[no]
cluster name
page 181
E, C
cluster shutdown
page 181
C
cluster upgrade
page 152
C
configuration
page 172
Table A.1 CLI Commands Documented in This Guide