Owner manual

AM456-9026A HP VMA SAN Gateway User’s Guide 73
3. To disable an NTP server, click the check box next server name in the NTP Servers panel.
Then, click Disable Server.
4. To remove an NTP server, click the check box next server name in the NTP Servers panel.
Then click Remove Selected Server.
To add an NTP server, do the following:
1. Select Administration > Network > NTP Settings.
2. Go to the Add New NTP Server panel and enter the new NTP Server IP address in the text
box.
3. Select a Version from the drop-down list:
•
3—Network Time Protocol (Version 3)
• 4—Network Time Protocol (Version 4)
Note: Ask your network administrator, if you are unsure which version to choose.
4. Specify whether or not you want the new NTP server enabled or disabled by choosing Yes or
No from the drop-down list.
5. Click Add NTP Server to add the server to the network.
Viewing and Modifying Web Admin Settings
You can change Web Interface configurations, disable the HP VMA Web Interface, configure HTTP
and HTTPS, set the inactivity time for automatic logouts, configure cookies, and show the HP VMA
Web Interface configuration settings.
Caution: Disabling the HP VMA Web Interface terminates your Web session, after which you can only access
the SAN Gateway cluster through the command line interface. For information of the CLI, see APPENDIX
A, “VMA SAN Gateway Command Line Interface Reference” on page 141.