HP ZBook 17 G2 Mobile Workstation Maintenance and Service Guide

4. Remove the battery (see Battery on page 41).
5. Remove the service cover (see Service cover on page 43).
6. Remove the optical drive (see Optical drive on page 52) or upgrade bay hard drive (see Upgrade Bay
hard drive on page 54).
7. Remove the keyboard (see Keyboard on page 57).
8. Remove the top cover (see Top cover on page 67).
9. Remove the graphics board fan/heat sink assembly (see Graphics subsystem heat sink on page 91).
Remove the graphics board:
1. Remove the two Torx T8M2.5×4.0 screws (1) that secure the graphics board to the system board.
2. Lift the right edge of the graphics board until it rests at an angle (2), and then remove it from the
connector (3).
Reverse this procedure to install the graphics board.
Component replacement procedures 95