HP ZBook 17 G2 Mobile Workstation Maintenance and Service Guide

4. Remove the two Phillips PM2.0×5.0 screws (1) that secure the top bracket to the hard drive carrier, and
then remove the bracket from the carrier (2).
5. Remove the four Phillips PM2.5×3.0 screws (1) that secure the hard drive to the carrier, and then pull
the hard drive away from the connector (2) to disengage it.
6. Remove the hard drive (3).
Reverse this procedure to reassemble and install the Upgrade Bay hard drive and Upgrade Bay hard drive
carrier.
Component replacement procedures 59