HP ZBook 17 G2 Mobile Workstation Maintenance and Service Guide

3. Remove the screw covers (1) and the two Phillips PM2.0x7.0 screws (2) that secure the display bezel to
the display enclosure.
The screw covers are available in the Display Panel Support Kit, spare part number 784211-001.
4. Flex the inside edges of the bottom edge (1), the left and right sides (2), and the top edge (3) of the
display bezel until the bezel disengages from the display enclosure and then remove the bezel (4).
NOTE: The top edge of the display bezel contains double-sided adhesive. Additional pressure may be
needed to detach the top edge of the display bezel from the display enclosure.
Reverse this procedure to install the display bezel.
Component replacement procedures 67