HP LaserJet Analog Fax Accessory 500 - Fax Guide

1. On the control panel, scroll to and touch the Administration icon to open the Administration
menu.
2. Scroll to and touch Initial Setup and then Fax Setup to open the fax menu.
3. Touch Fax Send Settings to see the Fax Send settings.
4. Scroll to and touch Billing Codes to see the billing code settings.
5. Touch Custom to enable billing codes.
NOTE: If you want to disable billing codes, touch Off, touch Save, and then skip the remaining
steps.
6. Touch Save to open the Billing Code screen.
7. Touch the text box to display the keyboard.
8. Type the minimum number of digits you want in the billing code, and then touch OK.
9. Touch Save.
Default job options
The following default job options are available for configuration:
●
Image Preview
●
Resolution
●
Original Sides
●
Notification
●
Content Orientation
●
Original Size
●
Image Adjustment
●
Optimize Text/Picture
●
Job Build
●
Blank Page Suppression
NOTE: Default job option settings are shared across all fax methods; analog, LAN, and internet fax.
Set the outgoing fax resolution
The outgoing fax resolution setting determines the maximum resolution supported by the receiving
fax. The fax accessory uses the highest possible resolution (as limited by this setting) and the
maximum resolution of the receiving fax.
NOTE: Faxes wider than 21.25 cm (8.5 inches) are automatically sent by using standard or fine
resolution, to reduce phone time.
NOTE: The default resolution setting is a lower dpi than previous product model default resolution
settings. For example, previous product models had a default resolution of FINE (200 x 200 dpi).
22 Chapter 2 HP Color LaserJet CM3530 MFP Series ENWW