HP PageWide 750, 765, 772, 776, 777, 780, 785, P75050, E75160, P75250, P77440, E77650, E77660, P77740, P77750, P77760, P77940, P77950, P77960 - Printhead Assembly Install Guide

8.3

8.5

8.4

8.6

At the right side of the printer, install the right-rear shipping restraint.

CAUTION: Verify that the shipping restraint is locked in place. shipping

restraints (supplied in the kit) must be used to avoid the following conditions:

• The printhead wiper can slide out of the printhead assembly when it

is removed.

• The replacement printhead assembly can become misaligned when it is

installed.

Remove three screws in the following order: Remove

one screw (PB1; callout 1), remove one screw (PB2; callout 2),

and then remove one screw (PB3; callout 3).

IMPORTANT: These screws must be removed/installed in the

correct order.

REINSTALL TIP: Reinstall these screws in the following order: Install one

screw (PB1; callout 1), install one screw (PB2;

Callout 2), and then install one screw (PB3; callout 3).

Install the right-front shipping restraint.

CAUTION: Verify that the shipping restraint is locked in place. shipping re-

straints (supplied in the kit) must be used to avoid the following conditions:

• The printhead wiper can slide out of the printhead assembly when it

is removed.

• The replacement printhead assembly can become misaligned when it is

installed.

At the rear of the printer, disconnect three FFCs (callout 1).

CAUTION: One FFC connector (callout 2) is a zero insertion force (ZIF)

connector. Open a small clip on the connector to remove the FFC.

 







1 2

J7Z09-90925.indd 8 8/3/2017 9:40:08 AM