HP PageWide MFP P77740-60 series - User Guide

I want to... Follow these steps The product then does this...
settings of media size and type to match the print
job and prints.
Print to a specic tray if
the media size and type
match; if they do not
match, print to another
tray.
●
Printer software: Select the tray you want.
●
Printer conguration: Under Settings, on the
Tray Management screen, Use Requested Tray
must be set to First.
Prints the job to the selected tray if the media size
and type match. If they do not match, the product
queries the other trays and prints from the rst one
with the correct media size and type.
For more information about printer software settings, see To print from a computer (Windows) or To print
from a computer (OS X).
Load media
This section describes how to load portrait-oriented paper into a tray for one-sided printing, which is the
factory default. Not all of the following trays or features may be available for your product:
●
Load Tray 1
●
Load Tray 2 (single) or Trays 2/3 (tandem)
●
Load lower 550-sheet trays
●
Load HCI trays
●
Load envelopes
●
Load letterhead or preprinted forms
●
Load the document feeder
●
Load the scanner
●
Reload the stapler
Load Tray 1
Tray 1 is the multipurpose tray at the left side of the product.
NOTE: If you are not using Alternate Letterhead Mode (ALM), place the paper as follows for one-sided
printing:
●
A4/Letter sized: Place portrait-oriented paper with the side to be printed on face-down, with the top
edge toward the back of the tray.
●
A3/Ledger sized: Place landscape-oriented paper with the side to be printed on face-down, with the top
edge toward the left.
For ALM orientation, see Load letterhead or preprinted forms.
1. Open Tray 1.
40 Chapter 4 Paper and print media ENWW