HP PageWide MFP P77740-60 series - User Guide
Load letterhead or preprinted forms
You can load letterhead, preprinted, or prepunched forms into any tray. Paper orientation depends on
whether you are printing in one-sided or two-sided mode. If Alternative Letterhead Mode (ALM) is enabled,
you can print in both one-sided and two-sided modes without reorienting the paper.
To enable or disable ALM from the control panel
1. Open the control panel dashboard (swipe the dashboard tab at the top of any screen downward, or
touch the strip at the top of the home screen).
2. On the control panel dashboard, touch (Setup).
3. Touch Tray and Paper Management, and then touch Alternative Letterhead Mode and turn it on or o.
To enable or disable ALM from the EWS
1. Type the product IP address into the address box of a web browser to open the EWS. (To obtain the
product IP, on the control panel dashboard, touch [Ethernet].)
2. Click the Settings tab.
3. Click Preferences , and then click Tray and Paper Management.
4. In the Alternative Letterhead Mode section, select Enabled or Disabled.
5. Click Apply.
To load letterhead or preprinted forms with ALM enabled
NOTE: With ALM enabled, you must select Letterhead, Preprinted, or Prepunched in the tray conguration
settings in the product control panel.
1. Load the A4/Letter-sized media face-up in the tray, with the top of the form to the back of the tray and
the long edges to the side.
2. Complete the steps in Load Tray 1, Load Tray 2 (single) or Trays 2/3 (tandem), Load lower 550-sheet
trays, or Load HCI trays.
To load letterhead or preprinted forms with ALM disabled
1. Orient the paper as follows for one-sided or two-sided print jobs:
●
One-sided: Load the A4/Letter-sized media face-down in the tray, with the top of the form to the
back of the tray and the long edges to the side.
ENWW Load media 47