HP LaserJet Pro MFP M28-M31 - Viiteopas

3
If your router supports Wi-Fi Protected Setup (WPS) mode, try to connect through this mode:
1. Press the WPS
button on your router.
2. Within two minutes, press and hold the Wireless
button on the printer control panel for at least three seconds, and then release the button.
TheWireless
LED and the Ready LED start blinking together.
3. Wait while the printer automatically establishes the network connection. It takes up to two minutes. When the network connection is established,
theWireless
LED stops blinking and remains on.
4. Continue to install the software.
Check the Wireless LED status from the printer control panel:
1. If the Wireless
LED is o, it means that the wireless connection is not established.
a. Press the Wireless
button on the printer control panel.
b. After the Wireless
LED starts blinking, continue to install the software. When the network connection is established, the Wireless LED stops
blinking and remains on.
2. If the Wireless
LED is on, it means that the wireless connection is established.
a. Check the network name (SSID) info on the Conguration Report/Network Summary: Press and hold the Start Copy
button until the
Ready
LED starts blinking. After you release the Start Copy button, the Conguration Report/Network Summary prints.
b. Make sure the computer is connected to the same wireless network to which you are connecting the printer.
c. Continue to install the software.
3. If the Wireless
LED is blinking, it means that the wireless connection is not established.
a. Restart the printer and the router.
b. Manually connect the printer to your wireless network. Use Wi-Fi Protected Setup (WPS) to connect the printer if the router supports WPS, orcontinue
to the next step.
c. Uninstall and reinstall the HP software.
Wireless printing
For more information on wireless
printingandwireless setup,
go to www.hp.com/go/wirelessprinting.