User Manual

Attaching the VESA mounting bracket
A VESA mounting bracket is included with the monitor for use when attaching the monitor panel to a wall,
swing arm, or other mounting xture.
1. Remove the monitor stand. Refer to Removing the monitor stand on page 10.
2. Remove the rubber plug from the screw hole in the center rear of the monitor.
3. Position the VESA bracket so that the connector tab on the bracket is aligned with the connector slot on
the monitor.
4. Press the VESA bracket (1) into the connector slot until it clicks into place.
5. Insert the screw included with the bracket through the bracket into the center screw hole in the monitor
(2) and tighten the screw.
6. Using an L-shaped screwdriver, install the four screws (3) into the monitor.
7. To attach the monitor to a swing arm or other mounting device, insert four mounting screws through the
holes on the mounting device and into the screw holes on the VESA bracket.
Setting up the monitor 11