HP DesignJet T1700 Z6 Z9 + Printer - Legal Information
5 Informasi peraturan
Nomor Model Resmi
Untuk tujuan identikasi resmi, produk Anda dilengkapi Nomor Model Resmi. Nomor Model Resmi produk Anda
adalah BCLAA-1702. Nomor resmi ini berbeda dengan nama pemasaran (misalnya, printer HP DesignJet) atau
nomor produk (misalnya, Z####X, dengan Z dan X adalah huruf dan # adalah angka).
Emisi kebisingan produk
Tingkat tekanan suara pada posisi penonton (LpA per ISO 7779) adalah < 70dB(A)
USA EMC ( Electro- Magnetic Compatibility)
The U.S. Federal Communications Commission (in 47 cfr15.105) has specied that the following notices be
brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Shielded cables: Use of shielded data cables is required to comply with the Class B limits of Part 15 of the FCC
Rules.
PERHATIAN: Pursuant to Part 15.21 of the FCC Rules, any changes or modications to this equipment not
expressly approved by the HP Company may cause harmful interference and void the FCC authorization to
operate this equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient the receiving antenna.
● Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
● Consult your dealer or an experienced radio/TV technician.
For further information, contact:
Manager of Corporate Product Regulations
12 Bab 5 Informasi peraturan IDWW