Compaq 325 and 326 Notebook PCs HP 425 and 625 Notebook PCs - Maintenance and Service Guide

Reverse this procedure to install the RTC battery.
Modem module
Description Spare part number
For use in all countries and regions except Australia and New Zealand 510100-001
For use only in Australia and New Zealand 510100-011
Before removing the modem module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 48).
5. Remove the service door (see
Service door on page 49).
6. Remove the hard drive (see
Hard drive on page 51).
7. Remove the optical drive (see
Optical drive on page 57).
8. Remove the fan (see
Fan on page 59).
9. Remove the palm rest (see
Palm rest on page 64).
10. Remove the keyboard (see
Keyboard on page 67).
11. Remove the top cover (see
Top cover on page 71).
12. Remove the system board (see
System board on page 90).
Remove the modem module:
1. Position the computer right-side up with the front toward you.
2. Remove the two Phillips PM2.5×3.0 screws (1) that secure the modem module to the system
board.
Component replacement procedures 97