HP LaserJet Managed MFP E72525, E72530, E72535, E77822, E77825, E77830 - On-Site Installation Guide

Table 8-9 On-site nal setup booklet maker nisher with punch (continued)
❑
Align the brackets on the engine to the holes on the nisher and roll the nisher against the engine.
❑
Push the locking rail in and install one screw to secure the nisher to the engine.
NOTE: If the locking rail won’t slide in easily, adjust the casters on the nisher to change the height.
NOTE: Check the vertical gap between the nisher and the engine. Adjust the casters for an equal gap from top to bottom.
NOTE: Remove the nisher from the engine if the MFP needs to be moved anything more than a very short distance.
HP LaserJet Stapler/Stacker Finisher
Click here to view a video of this procedure.
Please review the LaserJet A3 video for a complete understanding of the installation of each device. Use these
checklists as a reminder of the steps demonstrated in the videos.
Table 8-10 On-site nal setup stapler/stacker
❑
Power down the MFP.
❑
Unpack nisher, bridge and attachment hardware.
❑
Remove packing foam and tape from the bridge.
NOTE: E7 engines require the 2nd exit to be installed rst.
NOTE: E7 mono engines require a spacer to be installed before attaching a nishing option.
NOTE: On the engine, remove the bin full actuator, paper settling arms and face down bin.
❑
Install the bridge on the engine. Secure with one screw.
❑
Remove the packing foam and tape from the nisher.
❑
Open the top cover on nisher and remove the foam and tape inside the paper path.
❑
Open front door on nisher and remove packing foam and tape inside door..
❑
Remove the stapler shipping lock screw and label.
❑
Rotate the green wheel to the left until the spring loaded white tab is exposed under the stapler.
❑
Rotate the green wheel to the right until the stapler moves back to the front position and stops.
❑
While holding the green wheel, insert the staple cartridge holder into the stapler.
❑
Hang the lower tray support brackets on the horizontal bracket on the output side of the nisher.
❑
Secure each bracket with one screw.
❑
Note the alignment pins on the bottom of the tray and the corresponding holes on the support brackets.
❑
Position the tray over the brackets and push down rmly to seat the pins in the holes.
❑
While holding the tray from above, install four screws to secure the tray to the support brackets.
❑
Note the four tabs. Install the upper tray into the slots.
❑
Install front (F) and the rear (R) and the nisher attachment brackets on the left side of the engine.
❑
Secure with two screws in each bracket.
❑
Peel the cover o the connector near the rear bracket.
88 Chapter 8 Complete installation procedures ENWW