HP Color LaserJet Managed MFP E77800 Series, HP LaserJet Managed MFP E72500 Series - Warranty and Legal Guide
Product model number Regulatory model number
HP Color LaserJet Managed Flow MFP E77822z
HP Color LaserJet Managed Flow MFP E77825z
HP Color LaserJet Managed Flow MFP E77830z
BOISB-1603-01
European Union Regulatory Notice
Products bearing the CE marking comply with one or more of the following EU Directives as may be applicable:
Low Voltage Directive 2014/35/EU, EMC Directive 2014/30/EU, Eco Design Directive 2009/125/EC, RED
2014/53/EU, RoHS Directive 2011/65/EU.
Compliance with these directives is assessed using applicable European Harmonized Standards. The full
Declaration of Conformity can be found at the following website: www.hp.com/go/certicates (Search with the
product model name or its Regulatory Model Number (RMN), which may be found on the regulatory label.)
The point of contact for regulatory matters is: HP Deutschland GmbH, HP HQ-TRE, 71025 Boeblingen, Germany
The product meets the requirements of EN 55032 Class A, in which case the following applies: 'Warning – This is
a Class A product. In a domestic environment this product may cause radio interference in which case the user
may be required to take adequate measures.’
FCC regulations
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
NOTE: Any changes or modications to the printer that are not expressly approved by HP could void the user’s
authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class A limits of Part 15 of FCC rules.
Canada - Industry Canada ICES-003 Compliance Statement
CAN ICES-3(A)/NMB-3(A)
ENWW Regulatory statements 33