HP Enterprise printers and scanners - Imaging and Printing Security Best Practices (white paper)

Figure 28: Disabling Web Services Print.
Apply your Changes
Click the Apply button located in the bottom right hand corner to apply the settings to the selected devices.
Review your settings and then click the Configure Devices button to execute the configuration.
Configuring Security Settings
The Security category includes many advanced security settings and password settings. If you are attempting to configure a
setting that is in the Security category and not listed in this section, you should check the chapter on Advanced Security for multiple
MFPs. To set the basic required settings in this category follow the steps in the sections below.
Bootloader Password
The Bootloader password protects features, such as the MFP reset options that are available on the MFP control panel. These
features are not commonly known, but they can severely affect the MFPs if they are executed improperly. The Bootloader
password is not configured by default.
CAUTION:
Once you configure the bootloader password, the bootloader features will be inaccessible permanently without it. The only way to restore the default setting and
clear the password is to provide the correct password and set it with a blank password.
Be very careful to remember the configured bootloader password. A hardware replacement may be required to recover from a forgotten Bootloader Password.
On the Config tab under the Security category page, select the Bootloader Password option (Figure 28).