HP Enterprise printers and scanners - Imaging and Printing Security Best Practices (white paper)

Default Settings
This chapter lists the default setting for each configuration in the checklist:
Setting Default Setting
Configure HP Secure Hard Disk Installed and Enabled
Configure SNMPv3 (Security page). Not configured
I/O Timeout to End Print Job Not configured
Configure Job Hold Timeout. Never Delete
Enable Job Retention. Enabled
Job Storage Limit Enabled
e-Print Settings Disabled and Not Configured
Error Handling Dump then Reboot
HTTP Idle Timeout Enabled
Configure Enable Features options (do not disable
EWS Config at this point).
(See below)
Disable Telnet Config. Enabled
Disable SLP Config. Enabled
Disable FTP Printing. Enabled
Disable LPD Printing. Enabled
Enable 9100 Printing. Enabled
Disable Air Print Enabled
Disable IPP Printing. Enabled
Disable IPPS. Enabled
Disable MDNS Config. Enabled
Disable IPV Multicast Config. Enabled
Disable WS-Discovery. Disabled
TCP Idle Timeout Enabled
Web Services Print Enabled
Digital Sending Service Disabled
Embedded Web Server Password Disabled
Enable Host USB Disabled
Enable Encrypt all Web Communication. Enabled
Configure Encryption Strength to High. Low
Open/Print from USB Device Disabled
Configure the PJL Password. Not configured
Disable Printer Firmware Update. Enabled
52