HP LaserJet Enterprise, HP LaserJet Managed, HP PageWide Enterprise, HP PageWide Managed - Configuration Guide using the Embedded Web Server (EWS)

Step three: Congure a fax send method
Use one of the following methods, based on your needs, to congure a fax-send method:
●
Option one: Congure the internal modem
●
Option two: Congure LAN Fax Setup
●
Option three: Congure Internet Fax Setup
Option one: Congure the internal modem
Use the settings on the Internal Modem tab to congure the printer to send and receive faxes using its internal
modem.
1. In the Fax Send Setup area, click the Internal Modem tab.
2. Select the Country/Region, and then enter the Company Name and Phone Number in the Device Modem
Settings area. The country/region, company name, and phone number are displayed in the fax header of
sent faxes.
3. Set the general fax send settings in the General Fax Send Settings area. The following general fax send
settings are available:
● Fax Header (default is Prepend)
● Enable PC Fax Send (selected by default)
● Enable Error Correction Mode (selected by default)
● Enable JBIG Compression (selected by default)
4. Set the dialing settings in the Fax Dialing Settings area. The following dialing settings are available:
● Fax Dial Volume (default setting is Low)
● Dialing Mode (default setting is Tone)
● Dialing Prex
● Fax Send Speed (default setting is Fast)
● Redial Interval (default setting is 5)
● Redial on Error (default setting is 2)
● Redial on No Answer (default setting is 0)
● Redial on Busy (default setting is 3)
● Detect Dial Tone (not selected by default)
5. Select the Enable Billing Codes check box in the Billing Code Settings area to enable the use of billing codes
on the printer. Enter a default billing code value in the Default Billing Code eld. Enter a minimum length for
the billing code in the Minimum Length eld. Select the Allow users to edit billing code check box if
necessary.
238 Chapter 6 Congure printer features using the EWS ENWW